Initially I had printed out and cut out each individual piece of the fusion 360 model
and arranged them so I could make logical space of the model
I decided to tape together the pieces and fold them together to create a rough sketch model to see if the folds worked together...
Which the model found some success, I decided to further progress and to create the squares on the sheet of paper.
Tracing the shapes just in case I made a mistake...
and added tabs to the shapes so I could pursue the fold and tabs technique of paper model making.
Unfortunately the sizes of the transition space were not completely accurate due to tracing the shapes I had printed versus measuring the actual model since it was printed 1:1, thus resulting the botched transition space model.
Photos
No comments:
Post a Comment